HVAC Energy Savings Testimonial | 10-20% Reduction with STM-3
HVAC Energy Savings - STM-3 Dye and Conditioner
This testimonial documents 10-20% energy savings on electricity bills achieved with Cerma STM-3 treatment for air conditioning and refrigeration systems, verified by Dallas Superior Air Service.
Documented Savings
After 48 hours of running with STM-3, users report the amperage draw of the motor to be less. STM-3 helps provide more efficient cooling, fewer cycles, and longer lasting equipment.
Professional Verification
Thank you Dallas Superior Air Service for this information
"As an independent A/C and Heat Contractor, I was employed to measure the amperage draw of a Trane A/C unit at D & A American Bistro Restaurant in Plano, Texas. I was then asked to treat with STM-3 and return after 48 hours (1 day where the ambient temperature was comparable) to measure again. I did this and found the usage to be fluctuating between 2 and 2.3 amps less."
How STM-3 Reduces Energy Consumption
| Mechanism | Energy Benefit |
|---|---|
| Reduced Compressor Friction | Lower amperage draw - less electricity needed |
| Improved Heat Transfer | More efficient cooling per cycle |
| Smoother Operation | Fewer start/stop cycles |
| Lower Operating Temperature | Less stress on electrical components |
Key Benefits for HVAC Systems
- 10-20% reduction in electricity bills – Documented savings on cooling costs
- Extended equipment life – Less wear on compressor components
- Fewer service calls – More reliable operation
- Quieter operation – Reduced friction means less noise
- Works with all refrigerants – Compatible with R-22, R-410A, R-134a, and others
Applications
- Commercial HVAC – Restaurants, offices, retail stores
- Residential A/C – Home central air systems
- Refrigeration – Walk-in coolers, freezers, display cases
- Industrial Cooling – Chillers, cooling towers
How It Works
STM-3 is the world's only pure Synthetic ceramic metal treatment, proven to substantially decrease friction, reduce damaging harmonics and wear. It is compatible with refrigerant oil and does not harm seals, compressors, or systems. It acts as a carrier just as the lubricant does in an engine, treating metal surfaces with nano Silicon Carbide to create a permanent protective barrier.
Professional Installation
STM-3 needs to be introduced to a working system through the suction port while running. To gain maximum results it needs to be run for about 3 hours under load. Dosage: 1 oz per ton with a reasonable pipe distance. You cannot overdose, it is just economics.
Questions about Cerma STM-3 for your HVAC system? Call 239-344-9861 or email Info@cermatreatment.com