One (1) Cerma STM-3 2oz Engine Treatment
Five (5) Quarts of CERMAX Synthetic Motor Oil (choose your preferred viscosity and additional oil quantity if needed)

One (1) 1oz Turbo Nano Treatment (if Turbo/Induction option is chosen)
One (1) 2oz Manual Transmission Treatment (if Transmission option and type is chosen)

Use treatment first! Add treatment to existing oil (not Cerma Oil).
If your engine has less than 30,000 miles, add only 1oz of the Engine Treatment to your existing engine oil. If your engine has 30,000 miles or more, then add the full 2oz bottle. To add to the engine oil, the best method is to add it when the engine is warm and running at idle. If blowback is present, shut off the engine, add treatment to oil, and start the engine immediately. After adding, do not shut off the vehicle. Idle at 2000 RPMs for 2 to 3 minutes and then drive the car for a minimum of 15 to 20 minutes. It is preferred to drive in city stop-and-go traffic for the first 10 minutes, then freeway or high-speed driving for 10 minutes. Cerma uses all RPM ranges to provide proper distribution of the technology.
Put a minimum of 1,500 miles after adding engine treatment before the oil change interval (next step).
Change oil using CERMAX Motor Oil. (Do not utilize any other additives while using Cerma-branded oils).
Your part of the process is now complete. Over the next 90 days of driving, the Cerma process will complete its process on its own.

Use treatment first! Add treatment to existing oil (not Cerma Oil).
If your engine has less than 30,000 miles, add only 1oz of the Engine Treatment to your existing engine oil. If your engine has 30,000 miles or more, then add the full 2oz bottle. To add to the engine oil, the best method is to add it when the engine is warm and running at idle. If blowback is present, shut off the engine, add treatment to oil, and start the engine immediately. After adding, do not shut off the vehicle. Idle at 2000 RPMs for 2 to 3 minutes and then drive the car for a minimum of 15 to 20 minutes. It is preferred to drive in city stop-and-go traffic for the first 10 minutes, then freeway or high-speed driving for 10 minutes. Cerma uses all RPM ranges to provide proper distribution of the technology.
Put a minimum of 1,500 miles after adding engine treatment before the next step.
Add 1oz of Turbo Nano to hot engine oil. Drive as normal.
Put a minimum of 500 miles after adding Turbo Nano treatment before oil change (next step).
Change oil using CERMAX Motor Oil. (Do Not utilize any other additives while using Cerma branded Oils)
Your part of the process is now complete. Over the next 90 days of driving, the Cerma process will complete its process on its own.

***IMPORTANT: DO NOT ADD TREATMENT AND OIL AT THE SAME TIME! ADD TREATMENT, DRIVE A MINIMUM OF 1,500 MILES AND THEN CHANGE OIL.